GiD forum

Hi GiD Team,

I want to create a new condition with these parameters :
[*] CONDTYPE: over groups
[*] CONDMESHTYPE: over nodes
[*] GROUPALLOW: points lines surfaces nodes
So the condition should be applied to a group that can contain only points, lines, surfaces and/or nodes. So far, everything is fine except that when I open the condition data window for this condition, I can select points, lines, surfaces and also volumes although it's not allowed (cf. print-screen 1). However, if I apply another condition from another book on any entity and then open again the condition data window for this new condition, I can select only points, lines and surfaces, which is what I want (cf. print-screen 2). Do you have any idea why the condition data window behaves like this?


(We are using GiD v14.0.)

Thanks!

Sorry, something goes wrong with my attachments in the last post. There is my post again.
(PS: Is there any way to edit a post once it has been submitted? )

Hi GiD Team,

I want to create a new condition with these parameters :
[*] CONDTYPE: over groups
[*] CONDMESHTYPE: over nodes
[*] GROUPALLOW: points lines surfaces nodes
So the condition should be applied to a group that can contain only points, lines, surfaces and/or nodes. So far, everything is fine except that when I open the condition data window for this condition, I can select points, lines, surfaces and also volumes although it's not allowed (cf. print-screen 1). However, if I apply another condition from another book on any entity and then open again the condition data window for this new condition, I can select only points, lines and surfaces, which is what I want (cf. print-screen 2). Do you have any idea why the condition data window behaves like this?


(We are using GiD v14.0.)
Thanks!