[GiDlist] problems with Collapse Model
Posted: Wed Aug 21, 2013 2:20 pm
Dear GiD team,
I don 't understand why when I use the "Collapse Model" function, GiD
creates new points, lines and surfaces that complicates my initial model. I
want to mesh a topography and I m using NurbsLines and NurbsSurfaces.
In the same context, if I collapse a Model done with simple lines, these are
converted to Nurbslines, why?
Thank you for your advice.
Best regards,
José
___________________________________________________________
José Antonio Fernández Merodo
INSTITUTO GEOLÓGICO Y MINERO DE ESPAÑA
Departamento de Investigación y Prospectiva Geocientífica
Área de Riesgos Geológicos
c/ Ríos Rosas 23, 28003 Madrid, España
( +34 91349 5810
* mailto:jose.fernandez at igme.es jose.fernandez at igme.es
Web http://www.igme.es/ www.igme.es
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20130821/ff106e7c/attachment.htm
I don 't understand why when I use the "Collapse Model" function, GiD
creates new points, lines and surfaces that complicates my initial model. I
want to mesh a topography and I m using NurbsLines and NurbsSurfaces.
In the same context, if I collapse a Model done with simple lines, these are
converted to Nurbslines, why?
Thank you for your advice.
Best regards,
José
___________________________________________________________
José Antonio Fernández Merodo
INSTITUTO GEOLÓGICO Y MINERO DE ESPAÑA
Departamento de Investigación y Prospectiva Geocientífica
Área de Riesgos Geológicos
c/ Ríos Rosas 23, 28003 Madrid, España
( +34 91349 5810
* mailto:jose.fernandez at igme.es jose.fernandez at igme.es
Web http://www.igme.es/ www.igme.es
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20130821/ff106e7c/attachment.htm