Thank you. easy when you know how
In any case, in general, you cannot reconstruct a line only from his
control points. agreed but if it is only lines and arcs of known radius
then this is possible
cheers
mark
-----Original Message-----
From: Enrique Escolano [mailto:escolano at cimne.upc.edu]
Sent: 08 February 2005 16:08
To: gidlist at gatxan.cimne.upc.es
Subject: Re: [GiDlist] restore line (break up)
Before read this batch, set the general preference (utilities preferences)
create new point: to always
(else, GiD expects user confirmation before create new points very near of
other points)
In any case, in general, you cannot reconstruct a line only from his control
points.
Regards
Enrique
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.296 / Virus Database: 265.8.5 - Release Date: 03/02/2005
The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can correct
the error.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20050208/b1233b61/attachment.htm