[GiDlist] post-processing

[Thanh Chau Dinh]

Dear all:
Can you help me following problem?
I am using GiD 9.0.4. When I switch to post-processing mode I can not see
mesh as well as other results on the mesh. Someone might change options but
I could not fix it because I did not get this trouble before.
Thank you in advance.
Thanh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20100223/2933207d/attachment.htm

[escolano]

Maybe do you have set some unusual preference.

You can reset all preferences to the default ones by starting fom the Windows menu "GiD Safe mode" and selecting the "Reset preferences" option.

Enrique

----- Original Message -----
From: Thanh Chau Dinh
To: gidlist at gatxan.cimne.upc.edu
Sent: Tuesday, February 23, 2010 2:10 PM
Subject: [GiDlist] post-processing


Dear all:
Can you help me following problem?
I am using GiD 9.0.4. When I switch to post-processing mode I can not see mesh as well as other results on the mesh. Someone might change options but I could not fix it because I did not get this trouble before.
Thank you in advance.
Thanh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20100223/148ac2a3/attachment.htm