[ GiDlist ] geometrie creation

[ASSANELLI Andrea CINI]

Release 6.0 is available for download at CIMNE's web site (7726 Kb), check
the address above. I think you will find some directions about the manuals
there (I'm not sure).

Best regards,

Andrea Assanelli
Senior Research Engineer
CINI/FUDETEC
Buenos Aires
ARGENTINA


We have released today a new version of GiD, 6.0, for more details
please look at

http://gid.cimne.upc.es

Hope it helps . . .

best regards

miguel


----------------------------------------------------------------------------
----
Miguel A. de Riera Pasenau miguel at cimne.upc.es
http://gid.cimne.upc.es



-----Mensaje original-----
De: Sebastian Skatulla [mailto:sebastian at skatulla.com]
Enviado el: Lunes 21 de Agosto de 2000 20:42
Para: gidlist
Asunto: [ GiDlist ] geometrie creation


* Mail ingresado via internet. No se garantiza autenticidad *

Hi,

first of all, I didn't receive any mail until now. Is this list in use at
all?
If it did, my question as follows: in the user manual is described a
function 'planar surface creation', but I can't find that in
'geometrie-create' pull down. I need release 6.0 and the
corresponding user manual.
Thanks.

Sebastian

sebastian at skatulla.com

[Sebastian Skatulla]

Release 6.0 is available for download at CIMNE's web site (7726 Kb), check
the address above. I think you will find some directions about the manuals
there (I'm not sure).

I downloaded the newest manual as I got release 6.0. But the manual seems to be
newer than the program

Sebastian

[Javier Mora]

You can find the last manual version in the download page of GiD:
Search first the link "Download GiD user manual, reference manual and
examples" and then "GiD reference manual ( 2nd August 2000)", that I think
is correlated with the release 6.0, isn't it?
Javier


-----Original Message-----
From: owner-gid at gatxan.cimne.upc.es
[mailto:owner-gid at gatxan.cimne.upc.es]On Behalf Of Sebastian Skatulla
Sent: Tuesday, August 22, 2000 5:38 PM
To: gidlist at gatxan.cimne.upc.es
Subject: Re: [ GiDlist ] geometrie creation


Release 6.0 is available for download at CIMNE's web site
(7726 Kb), check
the address above. I think you will find some directions
about the manuals
there (I'm not sure).

I downloaded the newest manual as I got release 6.0. But the
manual seems to be
newer than the program

Sebastian

[Sebastian Skatulla]

You can find the last manual version in the download page of GiD:
Search first the link "Download GiD user manual, reference manual and
examples" and then "GiD reference manual ( 2nd August 2000)", that I think
is correlated with the release 6.0, isn't it?

Function 'geometry-create-plannar_surface' doesn't exists. But someone told me that the function 'NURBS_surface' does the same and that's right - I tried it!

Sebastian

sebastian at skatulla.com