[GiDlist] node numbering

[Aldo Ghisi]

Hello,

is it possible in GiD to number the nodes according the user requirement?
For example, I want to force GiD to use nodes 1-100 for one surface and
101-200 for another surface.

Thank you in advance
Best regards

ALDO GHISI
Ph.D. student
Department of Structural Engineering
Politecnico di Milano
Piazza Leonardo da Vinci 32, 20133 Milano, Italy
Tel.: +39 02 2399 4218
Fax.: +39 02 2399 4220
E_mail: ghisi at stru.polimi.it

[Enrique Escolano]

It is not possible to control the number of nodes or elements inside GiD,
you must
renumber it outside.

Enrique

----- Original Message -----
From: "Aldo Ghisi" ghisi at stru.polimi.it
To: gidlist at gatxan.cimne.upc.es
Sent: Tuesday, April 02, 2002 11:12 AM
Subject: [GiDlist] node numbering


Hello,

is it possible in GiD to number the nodes according the user requirement?
For example, I want to force GiD to use nodes 1-100 for one surface and
101-200 for another surface.

Thank you in advance
Best regards

ALDO GHISI
Ph.D. student
Department of Structural Engineering
Politecnico di Milano
Piazza Leonardo da Vinci 32, 20133 Milano, Italy
Tel.: +39 02 2399 4218
Fax.: +39 02 2399 4220
E_mail: ghisi at stru.polimi.it

_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist