[GiDlist] Request for a different "Draw Normals"

[Andrea Calaon]

Hi GiD team,
I use the command “Draw Normals” extensively, and for my
type of geometries, it would be much better to have a
command that displays the normals only on the active
layers, and not on all existing.
I think it would be useful to have the command like this
anyway, since is up to the user to select the layers to check


Thanks


Andrea Calaon

Ashurst Lodge, Ashurst
Southampton, Hampshire
SO40 7AA, UK
Tel. office: +44 23 80 293 223
Fax office: +44 23 80 292 853
Mobile: +44 7766 488 225
E-mail: andrea at beasy.com

[Enrique Escolano]

I dont' understand your sugerence.

If you use Utilities-DrawNormals-Colors, then only are draw the surfaces
located in active ("on") layers,
If you use Utilities-DrawNormals-Surfaces, then the user select the
desired surfaces (and the screen selection only affects "on" layers)

What's to you want ? Only draw normals of surfaces in the current layer to
use?

Enrique

----- Original Message -----
From: "Andrea Calaon" andrea at beasy.com
To: gidlist at gatxan.cimne.upc.es
Sent: Friday, December 05, 2003 1:57 PM
Subject: [GiDlist] Request for a different "Draw Normals"


Hi GiD team,
I use the command "Draw Normals" extensively, and for my
type of geometries, it would be much better to have a
command that displays the normals only on the active
layers, and not on all existing.
I think it would be useful to have the command like this
anyway, since is up to the user to select the layers to check
.
Thanks


Andrea Calaon

Ashurst Lodge, Ashurst
Southampton, Hampshire
SO40 7AA, UK
Tel. office: +44 23 80 293 223
Fax office: +44 23 80 292 853
Mobile: +44 7766 488 225
E-mail: andrea at beasy.com

_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist