[GiDlist] point analysis in 3D

[Billy Fälth]

Hello GID team

Is it possible to pick an arbitrary point in a 3D model to do a
point-analysis. I can not make it work. I can only do point-analyses at
nodes in my 3D model.



Best regards

/Billy



---

Billy Fälth

Clay Technology AB

Ideon Research Centre

223 70 LUND

Sweden

Tel +46 46 286 25 81

Mobile +46 070 286 32 93

Fax +46 46 13 42 30





-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20050517/f1d2069a/attachment.htm

[escolano]

With nodal-results, it is possible to select an existent node, or also another 3D coordinate (interpolating results).

Note: The control-a key swap between "join" and "nojoin" selection mode.
in "join" mode must pick a node or enter his identifier number, in "nojoin" mode must enter the coordinates x y (and z if is not zero).

Regards

Enrique Escolano

----- Original Message -----
From: Billy Fälth
To: gidlist at gatxan.cimne.upc.es
Sent: Tuesday, May 17, 2005 1:14 PM
Subject: [GiDlist] point analysis in 3D


Hello GID team

Is it possible to pick an arbitrary point in a 3D model to do a point-analysis. I can not make it work. I can only do point-analyses at nodes in my 3D model.



Best regards

/Billy



---

Billy Fälth

Clay Technology AB

Ideon Research Centre

223 70 LUND

Sweden

Tel +46 46 286 25 81

Mobile +46 070 286 32 93

Fax +46 46 13 42 30




-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20050517/1116e3fd/attachment.htm