[GiDlist] Volume Generation

[Amancherla, Sundar (Research)]

I am trying to build a geometry of irregular regions in a cube.

I am using a batch file. In the commands listed for volume generation I get messages like "line number 89 is 1 times into volume generation". There are quite a few of these...

I am not sure what the problem is and I can send the batchfile to anyone who likes to look at it and let me know what the problem is...

Thanks very much in advance.
--
Aman

[escolano]

Hello Aman.
The problem is that the selected entities it doesn't topologically close a
volume.
Probably it exists some gap (duplicated lines, etc).
Can Use: Utilities-Draw higherentities-Lines to show this gap

To bound a volume, all lines must have the higherentity value=2 (the line
must be boundary of two surfaces)

If yourself can't solve the problem then send to me your batch file, to test
it.

Regards
Enrique Escolano

----- Original Message -----
From: "Amancherla, Sundar (Research)" Sundar.Amancherla at geind.ge.com
To: gidlist at gatxan.cimne.upc.es
Sent: Friday, May 06, 2005 1:34 PM
Subject: [GiDlist] Volume Generation


I am trying to build a geometry of irregular regions in a cube.

I am using a batch file. In the commands listed for volume generation I
get messages like "line number 89 is 1 times into volume generation". There
are quite a few of these...

I am not sure what the problem is and I can send the batchfile to anyone
who likes to look at it and let me know what the problem is...

Thanks very much in advance.
--
Aman
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist