[GiDlist] coordinates of objects

[Nguyen, Binh]

Dear All;

Wondering if there is a way to automatically update the z-coordinate of
an object when moving the pointer. Currently, the x and y coordinates
are but the z one is always zero.

Regards
Binh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20060117/65cddf66/attachment.htm

[escolano]

SEC: U coordinates of objectsThis coordinate is the location where the new point will be located, and currently the work plane must be only the XY (Z=0).
It's not a coordinate over an object. To pick over an entity can use (when selecting coordinates) point in line, point in surface, or Join to pick and existent point.

Enrique
----- Original Message -----
From: Nguyen, Binh
To: gidlist at gatxan.cimne.upc.es
Sent: Tuesday, January 17, 2006 1:50 AM
Subject: [GiDlist] coordinates of objects


Dear All;

Wondering if there is a way to automatically update the z-coordinate of an object when moving the pointer. Currently, the x and y coordinates are but the z one is always zero.

Regards
Binh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20060117/909ca002/attachment.htm