win98 GiD6.3.0b
Dear GiD team,
I am having a problem writing out a mesh data file in my required format.
the following few lines from my .bas file are giving me problems:
*loop elems
*ElemsNum 1 29650 *ElemsMat *ElemsConec
*end elems
no mater what material I asign to my volume before meshing (linear tets),
the output file always shows the value 1 as the elements material.
If I do a write mesh then the output file shows the correct material number?
Whats going on?
Regards
Mark
\
Linx Printing Technologies plc
+44 (0)1480302100
http://www.linx.co.uk/
This e-mail may contain privileged/confidential information and may be
read, copied and used only by the intended recipient. If you have received
it in error, please contact the sender by return e-mail or by
telephoning +44 (0)1480 302100.
Please then delete the e-mail and do not disclose its contents to any
person.