GiD forum

Hi, i have these two messages in the postprocess:

1. File C:/xxx.gid/xxx.flavia.res is not an HDF5 file

2. Found EOF too early
in line 1 of file 'C:/Users/xxx.gid/xxx.flavia.res'.

I suppose something is wrong with my input data? Is there something else as error?

Thanks.

Which is the GiD problemtype that is calculating?
In seems that the results file is wrong, doesn't has any valid GiD format (ASCII, binary or HDF5)
Maybe the calculation program that has written has crashed without finish it or is unable to calculate because some wrong input data. Verify your conditions, materials, mesh..., and have a look to the calculation input file and some possible error file.

Thanks for your reply.
I use a GID Problem type from CODE_BRIGHT (Code_Bright_2024_03).