Page 1 of 1

Moment load to a 3D model

Posted: Tue Mar 01, 2022 4:41 pm
by nchar
Hello everyone,

How can I apply a moment load at a surface? Ideally, I would like to apply it at a point and then connect the point to the surface, but I don´t know how this can be done.
(I have also applied at the surface an horizontal load by converting it to kPa, but if there is a better way of applying it (like using a point), I would prefer it.)

Thank you in advance

Re: Moment load to a 3D model

Posted: Thu May 19, 2022 4:49 pm
by escolano
Can force a inner point on a surface (with a tolerance) to be a node of the surface mesh with
Mesh->Mesh criteria->Force points to->Surface mesh