GiD forum

Hi,

I'm trying to work with : triaxial_dry_tep_CB_2020_21.gid

My problem is when i change the conditions, after calculation the following message appears : "Some errors found in the results file:
No results found: definitions for 2 gauss points read."

Other thing, i don't know how to create deviatoric stress (stress increasing until a percent of axial deformation) in the data->conditions menu.

Thanks

This forum is for GiD questions (geometry, mesh, customization, postprocess,...), not for questions of an specific problemtype like CODE_BRIGHT.
We don't know anything about its use (boundary conditions to apply, simulation parameters, etc.), from the GiD point of view is a black-box.

Must ask this kind of questions to the problemtype solver developers. https://www.gidhome.com/forum/viewforum.php?f=27
In particular, we host a sub-forum for CODE_BRIGHT, post your inner solver questions in this place.

escolano wrote:This forum is for GiD questions (geometry, mesh, customization, postprocess,...), not for questions of an specific problemtype like CODE_BRIGHT.
We don't know anything about its use (boundary conditions to apply, simulation parameters, etc.), from the GiD point of view is a black-box.

Must ask this kind of questions to the problemtype solver developers. https://www.gidhome.com/forum/viewforum.php?f=27
In particular, we host a sub-forum for CODE_BRIGHT, post your inner solver questions in this place.

Hi, yes i noticed this. Thanks