No subject
Posted: Fri Jul 23, 2010 11:35 am
Utilities-List-Mass (note a check mark)
Then, when you list an entity (from the upper menu), instead the 'normal'
list information,
the mass information (length, area, volume) of the selected entities
(geometry or mesh) will be reported.
Enrique
----- Original Message -----
From: "Amancherla, Sundar (GE, Research)" Sundar.Amancherla at geind.ge.com
To: gidlist at gatxan.cimne.upc.edu
Sent: Monday, January 23, 2006 6:39 AM
Subject: [GiDlist] Output of Volume
Hi
I have divided a cube ([-0.5,0.5] on all the sides) in to many volumes. I
am able to write a batch file for reading the geometry. Is there a function
in GiD to output the volumes as dimensionless units as a function of the
total cube volume?
Thanks very much for your help in advance.
Best Regards,
--
Aman
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist
Then, when you list an entity (from the upper menu), instead the 'normal'
list information,
the mass information (length, area, volume) of the selected entities
(geometry or mesh) will be reported.
Enrique
----- Original Message -----
From: "Amancherla, Sundar (GE, Research)" Sundar.Amancherla at geind.ge.com
To: gidlist at gatxan.cimne.upc.edu
Sent: Monday, January 23, 2006 6:39 AM
Subject: [GiDlist] Output of Volume
Hi
I have divided a cube ([-0.5,0.5] on all the sides) in to many volumes. I
am able to write a batch file for reading the geometry. Is there a function
in GiD to output the volumes as dimensionless units as a function of the
total cube volume?
Thanks very much for your help in advance.
Best Regards,
--
Aman
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist