GiD forum

Dear GIDlist
I have a problem using GID v 10.0.4.when I am finishing calculate and enter postprocess,it always arises error as follows:

Besides,I calculate an example.After entering postprocess,the max step is 0.0073289.But I enter the max step is 100.
Could you help me? Thank you very much.
Does somebody also meet this problem, and we look forward to your solution!

Kind regards,
Xiao-long Zhao
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20110113/5b5087fb/attachment.htm

Could you send us the whole model, including results, to have a look?

Please, send it directly to escolano at cimne.upc.edu

Regards

Enrique Escolano
----- Original Message -----
From: 赵小龙
To: gidlist at listas.cimne.upc.edu
Sent: Thursday, January 13, 2011 10:19 AM
Subject: [GiDlist] TCL GiD_Process Mesh structured Lines


Dear GIDlist
I have a problem using GID v 10.0.4.when I am finishing calculate and enter postprocess,it always arises error as follows:


Besides,I calculate an example.After entering postprocess,the max step is 0.0073289.But I enter the max step is 100.
Could you help me? Thank you very much.
Does somebody also meet this problem, and we look forward to your solution!
Kind regards,
Xiao-long Zhao






------------------------------------------------------------------------------


_______________________________________________
GiDlist mailing list
GiDlist at listas.cimne.upc.edu
http://listas.cimne.upc.edu/cgi-bin/mailman/listinfo/gidlist
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20110113/890bfa43/attachment.htm