Page 1 of 1
[GiDlist] How can I to do to view node of the mesh?
Posted: Sat Sep 22, 2012 5:12 pm
by geraldos
Hi Everybody,
How can I to visualize node of the mesh?
My thanks,
Geraldo Belmonte
[GiDlist] How can I to do to view node of the mesh?
Posted: Mon Sep 24, 2012 5:00 pm
by escolano
You can swap the mode view / no view of the mesh nodes writting this in the
lower command line
Mescape view entities nodes escape
Enrique
----- Original Message -----
From: "geraldos"
geraldos at lncc.br
To:
gidlist at listas.cimne.upc.edu
Sent: Saturday, September 22, 2012 6:12 PM
Subject: [GiDlist] How can I to do to view node of the mesh?
Hi Everybody,
How can I to visualize node of the mesh?
My thanks,
Geraldo Belmonte
_______________________________________________
GiDlist mailing list
GiDlist at listas.cimne.upc.edu
http://listas.cimne.upc.edu/cgi-bin/mailman/listinfo/gidlist