Page 1 of 1
[GiDlist] Calculate the mesure of a volume
Posted: Fri Jun 15, 2012 7:50 pm
by fabio.scherillo at unina.it
Dear Sir Madame,
I am a GID customer, I use your software as pre an postprocessor for
beasy corrosion software.
I have a simple problem:
I create a volume enclosed between some surfaces, but I can't find the
way to measure it.
Thank you in advance for your answer
Best Regards
Fabio Scherillo
[GiDlist] More than one post processing files
Posted: Fri Jun 15, 2012 10:09 pm
by Farzam, Arash
Hi,
Can I have two post processing %1.post.res files that are written by
two different codes? Or can I merge them together by a command in the
batch file?
Thank You
[GiDlist] More than one post processing files
Posted: Mon Jun 18, 2012 10:22 am
by escolano
Yes, you can have several .post.res (or .post.msh) files, and can read them
in postprocess with Files-Open multiple... and select the files you want.
You can also have a file named 'model.post.lst' with the list of the
.post.res files to be read, and then instead of selecting a lot of files
you only need to select this one (and changing from pre to post this file
will be automatically read)
See help 'GiD customization-postprocess data files-postprocess list file
----- Original Message -----
From: "Farzam, Arash"
farzam at ostatemail.okstate.edu
To:
gidlist at listas.cimne.upc.edu
Sent: Friday, June 15, 2012 11:09 PM
Subject: [GiDlist] More than one post processing files
Hi,
Can I have two post processing %1.post.res files that are written by
two different codes? Or can I merge them together by a command in the
batch file?
Thank You
_______________________________________________
GiDlist mailing list
GiDlist at listas.cimne.upc.edu
http://listas.cimne.upc.edu/cgi-bin/mailman/listinfo/gidlist
[GiDlist] Calculate the mesure of a volume
Posted: Tue Jun 19, 2012 4:58 pm
by escolano
Utilities-Mass-Volumes...
and select the geometric volumes or mesh elements to know its approximated
volume.
----- Original Message -----
From:
fabio.scherillo at unina.it
To:
gidlist at listas.cimne.upc.edu
Sent: Friday, June 15, 2012 8:50 PM
Subject: [GiDlist] Calculate the mesure of a volume
Dear Sir Madame,
I am a GID customer, I use your software as pre an postprocessor for
beasy corrosion software.
I have a simple problem:
I create a volume enclosed between some surfaces, but I can't find the
way to measure it.
Thank you in advance for your answer
Best Regards
Fabio Scherillo
_______________________________________________
GiDlist mailing list
GiDlist at listas.cimne.upc.edu
http://listas.cimne.upc.edu/cgi-bin/mailman/listinfo/gidlist