Hello,
I wish to know the method to modify measurements of a volume in GiD. I have a cylinder with the following measurements:
first, circle
center: 0,0,0
normal: 0,0,1
radius: 25.4
second, volume
lenght: 50 on z (utility/copy/surface/translation=50/extrud surface)
How to make to pass the length to 60 on z. This to preserve surfaces, the volume, conditions...
I used: geometry/edit/move point, but lines distort themselves.
Thank you.
Patrick Chevalier.
----- La messagerie itinérante sans abonnement NetCourrier -----
Web : www.netcourrier.com Minitel : 3615 et 3623 NETCOURRIER
Tél : 08 36 69 00 21
[ GiDlist ] how to modify lenght of volume
Moderator: GiD Team