No subject
Posted: Sat Oct 20, 2001 5:23 pm
Hello,
i have a fundamental problem by generating a structured mesh (volume).
A simple case:
I have a cube where i need to divide the lines of the x-axe into 4 segments.
The lines of the y-axes into 5 and the lines of the z-axe into 6 segments.
I tried to generate the mesh like it is explained in the GiD Reference
Manual, but it did not work. Do I have to change some settings in the
preferences, or anywhere else?
The result of the generating was the division of the x-axe and the y-axe in
4 segments and the z-axe into 5 segments.
Thank you for your help
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Lars K?nnemann.vcf
Type: text/x-vcard
Size: 361 bytes
Desc: not available
Url : http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20011020/2ec7e9f4/attachment.vcf
i have a fundamental problem by generating a structured mesh (volume).
A simple case:
I have a cube where i need to divide the lines of the x-axe into 4 segments.
The lines of the y-axes into 5 and the lines of the z-axe into 6 segments.
I tried to generate the mesh like it is explained in the GiD Reference
Manual, but it did not work. Do I have to change some settings in the
preferences, or anywhere else?
The result of the generating was the division of the x-axe and the y-axe in
4 segments and the z-axe into 5 segments.
Thank you for your help
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Lars K?nnemann.vcf
Type: text/x-vcard
Size: 361 bytes
Desc: not available
Url : http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20011020/2ec7e9f4/attachment.vcf