[ GiDlist ] IGES import
Posted: Fri Jun 15, 2001 4:59 pm
Hello,
One useful GiD utility is the following:
Geometry-Create-NurbSurface-Trimmed select the surface
right button mouse contextual menu-Un trimm
It is a little bit hidden but interesting.
Regards,
--
Compass Ing. y Sistemas Dr. Ramon Ribó
http://www.compassis.com ramsan at compassis.com
c/ Manuel Girona, 61 bajos tel. +34 93 204 10 82
08034 Barcelona, Spain fax. +34 93 204 19 09
I'm going ro precise what I would like to do : importing the trimed
surfaces
without trimming them! I mean importing the base surfaces and the trimming
curves but not to perform the trimming. If GiD can do this, it would be
fantastic to debug such a bad file.
One useful GiD utility is the following:
Geometry-Create-NurbSurface-Trimmed select the surface
right button mouse contextual menu-Un trimm
It is a little bit hidden but interesting.
Regards,
--
Compass Ing. y Sistemas Dr. Ramon Ribó
http://www.compassis.com ramsan at compassis.com
c/ Manuel Girona, 61 bajos tel. +34 93 204 10 82
08034 Barcelona, Spain fax. +34 93 204 19 09
I'm going ro precise what I would like to do : importing the trimed
surfaces
without trimming them! I mean importing the base surfaces and the trimming
curves but not to perform the trimming. If GiD can do this, it would be
fantastic to debug such a bad file.