No subject
Posted: Tue Mar 20, 2001 2:40 pm
Hello,
Are there any particular examples using contact. I'm trying to run a dynamic finite element job using Gid and would like to use the software to determine the master and slave contact segments during pre-processing. Is gid capable of doing this?? If so how is this done?? Is this included in any tutorials or manuals??
Thanks in advance,
Matthew Profit,
University of Wales, Swansea
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20010320/867f5934/attachment.htm
Are there any particular examples using contact. I'm trying to run a dynamic finite element job using Gid and would like to use the software to determine the master and slave contact segments during pre-processing. Is gid capable of doing this?? If so how is this done?? Is this included in any tutorials or manuals??
Thanks in advance,
Matthew Profit,
University of Wales, Swansea
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20010320/867f5934/attachment.htm