GiD forum

The name "Gauss points" of the GaussPoints set in the result is not defined,
Only is defined the set name "GaussAllElements"

you must change the line:
Gausselement 2 10. 1 2 0 "Gauss points"
for:
Gausselement 2 10. 1 2 0 "GaussAllElements"

NOTE:
This is in the old posprocess format, it is recommended to use the new postprocess format (it requires GiD 6.1.4b or higher)
I' attach the file YangNew.flavia.res with this new (more readable) format .

Regards

----- Original Message -----
From: "iwhrstr" iwhrstr at public.bta.net.cn
To: gidlist at gatxan.cimne.upc.es
Sent: Sunday, December 30, 2001 7:37 AM
Subject: [GiDlist] results at gauss points





Hello, there,

we knew only one result to be viewed at one time, but the plastic strains at gauss points were not viewed. We want to get helps. Thanks a lot again.

Jarry F


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20020102/da9b3155/attachment.htm
-------------- next part --------------
A non-text attachment was scrubbed...
Name: yangNew.flavia.res
Type: application/octet-stream
Size: 23803 bytes
Desc: not available
Url : http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20020102/da9b3155/attachment.obj