Page 1 of 1
[GiDlist] Dimensions in PostProcessor Mode
Posted: Wed Oct 29, 2003 5:13 am
by Philippe Bouchilloux
Hello:
I noticed that if dimensions are used and if they are not hidden before
going to postprocessor mode (by placing them into a layer which is turned
off), then it is not possible to remove them from the postprocessor display.
Philippe
[GiDlist] Dimensions in PostProcessor Mode
Posted: Wed Oct 29, 2003 3:15 pm
by Enrique Escolano
Yes, they are not created in postprocess any set to "contain" the
dimensions.
The only trick to hide this dimension in postprocess is to swep between
hide/show all the dimensions with the command
escape escape escape View entities dimensions
(Warning: the dimensions remain hide or show also when return to preprocess)
This must be enhanced for next versions.
Enrique Escolano
----- Original Message -----
From: "Philippe Bouchilloux"
pb at magsoft-flux.com
To: "GiDList"
gidlist at gatxan.cimne.upc.es
Sent: Wednesday, October 29, 2003 5:11 AM
Subject: [GiDlist] Dimensions in PostProcessor Mode
Hello:
I noticed that if dimensions are used and if they are not hidden before
going to postprocessor mode (by placing them into a layer which is turned
off), then it is not possible to remove them from the postprocessor
display.
Philippe
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist