GiD forum

Dear GiD users,

I wonder if one could retrieve field result (say displacement) given point
coordinates through GiD postprocess. Note mesh and analysis are done
outside GiD, and I dump data to GiD for postprocess.

More specifically, I have a 3D solid model, and I want to produce a x-y
plot of displacement field along a line path. A set of point coordinates
(not nodal coordinates) are used to define the path. I need retrieve field
result for these points to get the plot.

thanks, Steven

It's possible to create a "Cut Wire", but the points to define the linear
path must be over a element edge.
After can make a border graph selecting this cut wire.

Enrique Escolano

----- Original Message -----
From: "Steven Xu" sx25 at cornell.edu
To: gidlist at gatxan.cimne.upc.es
Sent: Thursday, September 18, 2003 6:03 PM
Subject: [GiDlist] retrieve field result given point coordinates


Dear GiD users,

I wonder if one could retrieve field result (say displacement) given point
coordinates through GiD postprocess. Note mesh and analysis are done
outside GiD, and I dump data to GiD for postprocess.

More specifically, I have a 3D solid model, and I want to produce a x-y
plot of displacement field along a line path. A set of point coordinates
(not nodal coordinates) are used to define the path. I need retrieve field
result for these points to get the plot.

thanks, Steven


_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist