GiD forum

Hi GiD team
I am using material to apply what are effectively surface boundary
conditions (no volumes are created) e.g. see part of .mat file below:

NUMBER: 1 MATERIAL: 1
QUESTION: Value
VALUE: 0.0
QUESTION: surface_condition:#CB#(Potential,Charge)
VALUE: Potential
END MATERIAL
NUMBER: 1 MATERIAL: 2
QUESTION: Value
VALUE: 0.0
QUESTION: surface_condition:#CB#(Potential,Charge)
VALUE: Potential
END MATERIAL

etc..

now when I do Materials-draw-all materials my surfaces are shown coloured
but I don't know which condition was applied. Is there any way of using the
.sim file and a symbol geometry files to attach a different symbol to each
material depending on if it is a Potential or Charge?

Best regards
Mark

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.502 / Virus Database: 300 - Release Date: 18/07/2003



The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can correct
the error.

It's not possible to draw a symbol for a material.
In your case, it seems best to use a condition instead a material
And, it has sense to predefine two materials with the same fields and
values?

Enrique
----- Original Message -----
From: "Mark Smith" mark.smith at linx.co.uk
To: "Gidlist (E-mail)" gidlist at gatxan.cimne.upc.es
Sent: Thursday, July 31, 2003 6:18 PM
Subject: [GiDlist] .sim file & conditions


Hi GiD team
I am using material to apply what are effectively surface boundary
conditions (no volumes are created) e.g. see part of .mat file below:

NUMBER: 1 MATERIAL: 1
QUESTION: Value
VALUE: 0.0
QUESTION: surface_condition:#CB#(Potential,Charge)
VALUE: Potential
END MATERIAL
NUMBER: 1 MATERIAL: 2
QUESTION: Value
VALUE: 0.0
QUESTION: surface_condition:#CB#(Potential,Charge)
VALUE: Potential
END MATERIAL

etc..

now when I do Materials-draw-all materials my surfaces are shown coloured
but I don't know which condition was applied. Is there any way of using
the
.sim file and a symbol geometry files to attach a different symbol to each
material depending on if it is a Potential or Charge?

Best regards
Mark

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.502 / Virus Database: 300 - Release Date: 18/07/2003



The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for
the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of
this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can
correct
the error.
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist