[GiDlist] precision of GID
Posted: Wed Feb 19, 2003 12:28 pm
Hello
I have a question about the internal precision of GID. How many digits does
GID use when representing the coordinates of the nodes? I have a model,
which has a maximum dimension of 2 meters and a minimum distance between
nodes of 0.25 mm. When I load the result file in the postprocessor I get the
message “Finding edges: Problems with the triangle nr..” and the mesh is
deformed in a strange way. Could this be due to the precision of GID maybe
the precision in the result file?
Regards
BF
Billy Fälth
Clay Technology AB
Ideon Research Center
S 223 70 Lund, SWEDEN
Tel +46 46 286 25 81
Fax +46 46 13 42 30
www.claytech.se http://www.claytech.se/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20030219/73f6e1d4/attachment.htm
I have a question about the internal precision of GID. How many digits does
GID use when representing the coordinates of the nodes? I have a model,
which has a maximum dimension of 2 meters and a minimum distance between
nodes of 0.25 mm. When I load the result file in the postprocessor I get the
message “Finding edges: Problems with the triangle nr..” and the mesh is
deformed in a strange way. Could this be due to the precision of GID maybe
the precision in the result file?
Regards
BF
Billy Fälth
Clay Technology AB
Ideon Research Center
S 223 70 Lund, SWEDEN
Tel +46 46 286 25 81
Fax +46 46 13 42 30
www.claytech.se http://www.claytech.se/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20030219/73f6e1d4/attachment.htm