[GiDlist] adding a point to a geometry
Posted: Thu Apr 29, 2004 4:00 pm
Hello,
Is it possible to add a point (points)
to an existing geometry, say, a cylinder,
so that the GID mesh generator will produce
mesh nodes at given points.
Thank you in advance!
Gassan
--
----------------------------------------------------
Gassan Abdoulaev, PhD
Dept. of Biomedical Engineering
Columbia University
Mudd Bldg., ET351, Mail Code 8904
500 West 120th Street, New York, NY 10027, USA
phone: (212)854 5737
fax: (212)854 8725
email: gsa2001 at columbia.edu
Is it possible to add a point (points)
to an existing geometry, say, a cylinder,
so that the GID mesh generator will produce
mesh nodes at given points.
Thank you in advance!
Gassan
--
----------------------------------------------------
Gassan Abdoulaev, PhD
Dept. of Biomedical Engineering
Columbia University
Mudd Bldg., ET351, Mail Code 8904
500 West 120th Street, New York, NY 10027, USA
phone: (212)854 5737
fax: (212)854 8725
email: gsa2001 at columbia.edu