[GiDlist] Visualization in 3D
Posted: Thu Apr 22, 2004 5:12 pm
Hello
I have a question about how GID handles different sets in post processing
mode. When I postprocess a 2D model, the different materials are put into
different surface sets but when I post process a 3D model, I only get one
volume set and no surface sets. Thus, I can’t show the different material
one by one. What can I do to come around this? When I mesh my 3D model, I
only mesh the volumes. Do I need to mesh also the surfaces to get a better
visualization in the postprocessor?
Regards
BF
Billy Fälth
Clay Technology AB
Ideon Research Center
S 223 70 Lund, SWEDEN
Tel +46 46 286 25 81
Fax +46 46 13 42 30
www.claytech.se http://www.claytech.se/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20040422/f876d9c9/attachment.htm
I have a question about how GID handles different sets in post processing
mode. When I postprocess a 2D model, the different materials are put into
different surface sets but when I post process a 3D model, I only get one
volume set and no surface sets. Thus, I can’t show the different material
one by one. What can I do to come around this? When I mesh my 3D model, I
only mesh the volumes. Do I need to mesh also the surfaces to get a better
visualization in the postprocessor?
Regards
BF
Billy Fälth
Clay Technology AB
Ideon Research Center
S 223 70 Lund, SWEDEN
Tel +46 46 286 25 81
Fax +46 46 13 42 30
www.claytech.se http://www.claytech.se/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20040422/f876d9c9/attachment.htm