Page 1 of 1
[GiDlist] How to display the z-coord
Posted: Fri May 20, 2005 12:25 am
by Nguyen, Binh
Hello;
Wondering if the z-coord of the mesh can be displayed on the screen (as the X and Y coords)?
Regards
Binh Nguyen
[GiDlist] How to display the z-coord
Posted: Fri May 20, 2005 4:10 pm
by escolano
You can get the coordinates of a node with
Utilities-Id
or listing them with
Utilities-List-Nodes
----- Original Message -----
From: "Nguyen, Binh"
binh.nguyen at dsto.defence.gov.au
To:
gidlist at gatxan.cimne.upc.es
Sent: Friday, May 20, 2005 1:01 AM
Subject: [GiDlist] How to display the z-coord
Hello;
Wondering if the z-coord of the mesh can be displayed on the screen (as
the X and Y coords)?
Regards
Binh Nguyen
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist