[GiDlist] restore line (break up)

[escolano]

It doesn't exists any funcion to automatically break a curve on this
"special" points (hight curvature changes, etc).
And you don't know the exact curve paremeter to manually divide it.

Maybe for next versions we will remove this "join tangent lines" filter from
the "Collapse" function, and put as a separated funcion.
We will also think about to implement some function to detect and/or divide
curves/surfaces from this special points.

Enrique Escolano

----- Original Message -----
From: "Mark Smith" mark.smith at linx.co.uk
To: "Gidlist (E-mail)" gidlist at gatxan.cimne.upc.es
Sent: Friday, February 04, 2005 6:10 PM
Subject: [GiDlist] restore line (break up)


win2000 gid6.3.0b

Hi Gid team

The attached model is a square with rounded corners produced from a square
&
then performing an arc tangents operation at each corner. I have then
collapsed the lines to give me just 1 line instead of 4 lines and 4 arcs.
Question: is it possible (undo is not an option in my real case) to break
this line back into it's constituent parts again (points lines & arcs)?
if I do an edit nurbs line it shows me all the original points etc how can
I
get them back again?

best regards
mark

--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.296 / Virus Database: 265.8.5 - Release Date: 03/02/2005



The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for
the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of
this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can
correct
the error.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20050208/53ec3703/attachment.htm