After apply the conditions over the geometry, you must re-generate the mesh
to transfer the conditions over nodes or elements.
Send us your problem type files (your calculus program is not required) and
a small sample to check it.
Regards.
Enrique Escolano
----- Original Message -----
From: "edodo" edodo at eyou.com
To: gidlist at gatxan.cimne.upc.es
Sent: Sunday, December 30, 2001 7:44 AM
Subject: [GiDlist] About .bas files
Hello there
I want to list the condition what set on the geometry such as set the
load on a face.
Now I can list the condition What have set on the Elements or on the
Nodes.Who could give
me some helps?Which commands can get the information about the elements
being involved in the
face which be setted the condition ?Thanks a lot in adbance.
Happy new year ,2002!
edodo
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist
[GiDlist] About .bas files
Moderator: GiD Team