[GiDlist] 7.3b and visualizing of boundary condition

[Andrea Calaon]

Hi everyone,
I'm using the GiD 7.3b version and I found some problems in
visualizing the boundary conditions on surfaces with colours.
Sometimes, if the surfaces with a certain b.c. overlap, in the
visualization, the colours are displayed wrongly. I had this problem
with quadrilateral elements.

Another question:
Is it for debugging reasons that at the end of the meshing process
(and in few other cases) GiD 7.3b waits some seconds before
showing the mesh?

Regards


Andrea Calaon

Ashurst Lodge, Ashurst
Southampton, Hampshire
SO40 7AA, UK
Tel. office: +44 23 80 293 223
Fax office: +44 23 80 292 853
Mobile: +44 7766 488 225
E-mail: andrea at beasy.com

[Enrique Escolano]

please, send us a small sample with this visualization problem
(send directly to escolano at cimne.upc.es)

This delay after meshing it can be because there are transferring the
conditions from the geometry, renumbering nodes and calculating the mesh
boundary, etc.

Enrique Escolano

----- Original Message -----
From: "Andrea Calaon" andrea at beasy.com
To: gidlist at gatxan.cimne.upc.es
Sent: Tuesday, May 27, 2003 3:25 PM
Subject: [GiDlist] 7.3b and visualizing of boundary condition


Hi everyone,
I'm using the GiD 7.3b version and I found some problems in
visualizing the boundary conditions on surfaces with colours.
Sometimes, if the surfaces with a certain b.c. overlap, in the
visualization, the colours are displayed wrongly. I had this problem
with quadrilateral elements.

Another question:
Is it for debugging reasons that at the end of the meshing process
(and in few other cases) GiD 7.3b waits some seconds before
showing the mesh?

Regards


Andrea Calaon

Ashurst Lodge, Ashurst
Southampton, Hampshire
SO40 7AA, UK
Tel. office: +44 23 80 293 223
Fax office: +44 23 80 292 853
Mobile: +44 7766 488 225
E-mail: andrea at beasy.com

_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist