Simulation support with GiD Simulation?

valleytrojan · Post by **valleytrojan** » Fri Dec 13, 2024 8:15 am

Hello everyone!!

I just started using GiD Simulation for an engineering project and am having trouble setting up the simulation parameters. Specifically, I need guidance on how to optimize the element mesh and ensure the highest accuracy in the results. Also, are there any useful documents or tips for beginners to use this software more effectively? I look forward to receiving sharing from those with experience.

Thanks a lot!

Post by **escolano** » Wed Dec 18, 2024 6:44 pm

GiD is a neutral pre/postprocessor, in is coupled to several 'simulation problemtypes'.
The requirements of the 'mesh quality' are different for a structural simulation, a CFD simulation, etc.

Start following the 'GiD user manual'
https://www.gidsimulation.com/gid-for-s ... t/manuals/

GiD forum