condition over groups with groupallow

Moderator: GiD Team

Post Reply
JFlock_BE
Posts: 15
Joined: Thu Jul 11, 2019 6:57 am
Location: Liège, Belgium
Contact:

condition over groups with groupallow

Post by JFlock_BE »

Hi GiD Team,

I want to create a new condition with these parameters :
[*] CONDTYPE: over groups
[*] CONDMESHTYPE: over nodes
[*] GROUPALLOW: points lines surfaces nodes
condtion-over-group.PNG
condtion-over-group.PNG (26.38 KiB) Viewed 3572 times
So the condition should be applied to a group that can contain only points, lines, surfaces and/or nodes. So far, everything is fine except that when I open the condition data window for this condition, I can select points, lines, surfaces and also volumes although it's not allowed (cf. print-screen 1).
condtion-over-group.PNG
condtion-over-group.PNG (26.38 KiB) Viewed 3572 times
However, if I apply another condition from another book on any entity and then open again the condition data window for this new condition, I can select only points, lines and surfaces, which is what I want (cf. print-screen 2).
condtion-over-group.PNG
condtion-over-group.PNG (26.38 KiB) Viewed 3572 times
Do you have any idea why the condition data window behaves like this?


(We are using GiD v14.0.)

Thanks!
Attachments
print-screen-2.png
print-screen-2.png (2.4 KiB) Viewed 3572 times
print-screen-1.png
print-screen-1.png (2.72 KiB) Viewed 3572 times
JFlock_BE
Posts: 15
Joined: Thu Jul 11, 2019 6:57 am
Location: Liège, Belgium
Contact:

Re: condition over groups with groupallow

Post by JFlock_BE »

Sorry, something goes wrong with my attachments in the last post. There is my post again.
(PS: Is there any way to edit a post once it has been submitted? )

Hi GiD Team,

I want to create a new condition with these parameters :
[*] CONDTYPE: over groups
[*] CONDMESHTYPE: over nodes
[*] GROUPALLOW: points lines surfaces nodes
condtion-over-group.PNG
condtion-over-group.PNG (26.38 KiB) Viewed 3563 times
So the condition should be applied to a group that can contain only points, lines, surfaces and/or nodes. So far, everything is fine except that when I open the condition data window for this condition, I can select points, lines, surfaces and also volumes although it's not allowed (cf. print-screen 1).
print-screen-1.png
print-screen-1.png (2.72 KiB) Viewed 3563 times
However, if I apply another condition from another book on any entity and then open again the condition data window for this new condition, I can select only points, lines and surfaces, which is what I want (cf. print-screen 2).
print-screen-2.png
print-screen-2.png (2.4 KiB) Viewed 3563 times
Do you have any idea why the condition data window behaves like this?


(We are using GiD v14.0.)
Thanks!
Post Reply